To prevent injury to the user or other people and property damage, the following instructions must be
followed. Incorrect operation may cause harm or damage.
Your air conditioner should be protected from
moisture. e.g. condensation, splashed water, etc.
Do not place or store your air conditioner where
it can fall into water or any other liquid.
Unplug immediately.
Always transport your air conditioner in a vertical
position and place on a stable, level surface
during
use.
Turn off the product when not in use.
Always contact a qualified person to carry out
repairs. If the supply cord is damaged it must be
repaired by a qualified repairer.
Keep an air path of at least 12 in. all around the
unit from walls, furniture and curtains.
If the air conditioner is knocked over during use,
turn off the unit and unplug
immediately.
SAFETY PRECAUTIONS
!
Always do this
Do not operate your air conditioner in a wet room
such as a bathroom or laundry room.
Do not touch the unit with wet or damp hands or
when barefoot.
Do not press buttons with
anything other than
fingers.
Do not remove any fixed covers. Do not use this
appliance if it is not working properly, or if it has
been dropped or damaged.
Never use the power plug to turn unit on or off.
Do not cover or obstruct the inlet or outlet grilles.
Do not use hazardous chemicals to clean or
come into contact with the unit. Do not use in
the presence of inflammable substances or
vapor such
as alcohol, insecticides, gasoline, etc.
Do not allow children to operate the unit
unsupervised.
Do not use this product for functions other than
those described in this instruction manual.
Never do this
Energy Save
Use the unit in the recommended room size.
Place
the unit where nothing can obstruct the air flow.
Keep blinds/curtains closed during the sunniest part of the day.
Keep the filters clean.
Keep doors and windows closed to keep cool air in and warm air out.
The air conditioner must be operated within the temperature range indicated below:
Operating conditions
Safety rules
Suggested tools for window kit installation
1. Screwdriver(medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw(In case the window kit needs to be cut for the window to fit for direct installation)
MODE
ROOM TEMPERATURE
COOL
DRY
O
O
O
O
17 C(62 F)~35 C(95 F)
O
O
O
O
13 C(55 F)~35 C(95 F)
HEAT (heat pump type)
O
O
O
O
5 C(41 F)~30 C(88 F)
HEAT (electrical heat type)
O
O
<30 C/88 F
Note: Performance may be reduced outside of these operating temperatures.
2
