33
EN
33
EN
Recording
Playback
Editing
Introduction
Connections
Basic
Setup
Function
Setup
Others
Español
SATELLITE LINK
7
Press [OK].
“To Standby Mode” is highlighted.
8
Press [OK] again.
Satellite Link
Start Mode
5:00PM SP (2Hr)
To Standby Mode
In a second, the unit will be turned off
automatically as it goes into the satellite link
standby mode.
To cancel the satellite link function while in
the satellite link standby mode:
Press [STANDBY/ON
y
] to turn on the unit.
To cancel the satellite link function while the
satellite link recording is in progress:
Press [
C
STOP] on the front panel of the unit.
Notes
• If the signal of external input breaks up over 5 seconds, satellite link function will be canceled.
• If you have not set the clock, “Clock Setting” menu will appear at step 3. Follow to step 4 in “SETTING THE CLOCK”
on page 23.
• You cannot set the end time for the satellite link timer recording on this unit.
• Recording picture will be distorted if the copy protection signal is being detected during satellite link timer
recording.
• You can record the satellite link by using S-video input jacks on the rear panel. Refer to page 11 for more
information.
• When a regular timer recording and the satellite link timer recording are overlapped, those recordings are
recorded as illustrated below.
• Press [TIMER PROG.] during the satellite link timer recording to check the satellite link timer recording in
progress.
example 2
actual
recording
timer
recording
satellite link
example 3
actual
recording
timer
recording
satellite link
The first 2 minutes (at the longest) will be cut off.
example 1
timer
recording
actual
recording
satellite link
The first 2 minutes (at the longest) will be cut off.
