88
EN
TROUBLESHOOTING
Symptom
Remedy
DVD
The disc tray does not open when you
press
[OPEN/CLOSE
A
]
.
• It may take a few seconds for the disc tray to open after you have
recorded or edited a disc. This is because the unit is adding disc data to
the disc.
“Repairing” appears on the TV screen.
Repairing
• If there is a power failure or unplugging during recording, finalizing,
formatting or editing (even after “Repairing” disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
In a case you intend to cancel the
repairing process.
Repairing
Do you want to cancel a repairing
process? When selecting “Yes”,
the disc may not be usable.
Yes
No
• If you intend to cancel the repairing process, press
[
A
OPEN/CLOSE]
on the front panel, then select “Yes” and press
[OK]
. After that, press
[OPEN/CLOSE
A
]
to take out the disc.
The disc canceled during the
repairing process MAY NOT work.
VCR
Picture noise appears.
• Head cleaning for VCR may be necessary. Refer to “Auto head cleaning”
(page 4).
• Adjust tracking control for better picture by pressing
[TRACKING / ]
while you are playing back a cassette tape.
The cassette tape does not play back.
• No cassette tape is inserted.
Recording does not start after you press
[REC]
.
• Make sure the cassette tape has an erase-protection tab when you
record to a cassette tape. If needed, cover the hole with cellophane
tape.
The remote control does not function.
• Check if a cassette tape is in this unit.
The motor rotates even when
playback / recording is stopped.
• The motor may rotate for the duration of approximately 5 minutes for
efficient operation. This is not a malfunction.
E9P8BUD_ZV427MG9_v1.indd 88
2009/01/27 17:09:37
