2/3
LH71 Change of display resolution (polarity)
Press key to select the conditions for the addition display.
When you have made your selection, press key to save your settings.
With the display , press key once.
The display will be (additional display).
Press key to select the addition display.
Diameter display
(LH71-3 only)
If you press key once, it will automatically enter the advanced setting mode and display.
Press key to enter normal count mode.
Selection of additive display (LH71-3)
* If the display does not change to “Add”, “LATHE” is not selected in “TYPE”.
Input 3 - Input 2
Input 2
Input 3
Input 2 + Input 3
Input 2 - Input 3
- (input 2 + Input 3)
Addition display (input conditions to
be displayed on the Z axis)
Angle display
Length display
NOTE 1
: Selection of a value smaller than the basic setting measurement unit
resolution is not displayed.
NOTE 2
: The angle display can be set when the angle resolution is selected in
the basic settings.
NOTE 1
NOTE 2
Selection of display resolution
Press key once to display the display resolution of each axis.
Press key of the axis you want to change and select the resolution.
Please note that the lamp lights up once every two times and the diameter display is set.
When you have made your selection, press key to save your settings.
Press key to return to the normal counting state.
Set to the detailed settings mode.
Press key while the normal count mode is energized.
The display will be . (Detailed setting mode)
Set to basic setting mode.
Turn
key "ON" while the AC adapter is energized.
Press and hold
key for 3 seconds after the lamp changes from blinking to off.
The display will be
.
Basic settings
⇒
Addition display
⇒
Change
Detailed settings
⇒
Display resolution
⇒
Change
①
②
③
About 2 sec
④
⑤
Switch from basic settings to normal count mode.
Press
key once and the display will change to
.
Press
key once and the display will change to
.
Expansion
Extended key
①
②
