12
(E)
3-8. Mounting the Interpolator
Mount the interpolator by using the mounting holes at the
top and bottom of the mainframe and the mounting screws
(M4 × 10) provided. Refer to “6. Dimensions” for mounting hole
dimensions.
To connect the Head cable connector, reference point connector
and output connector to the interpolator, insert it into the position
shown in the Fig. 3-1 until it clicks into place. Aft er mounting
the interpolator, take care not to subject these connectors to any
unnecessary force since this can cause them to fail.
ALM
LEVE
L
SP
EE
D
MJ100
OFF OFF
ON OFF
OFF ON
ON ON
AB
S
OFF
1
1
2
3
4
5
4
6
7
8
7
9
1
9
1
0
2
3
5
6
8
0
ON
MO
DE
Output connector
Reference point connector
Head cable connector
Note
• Insert the connectors at the designated position (Refer to
Fig. 3-1) or the connectors may be damaged.
• Always cover the connector socket of the reference point
connector with the supplied connector cap when the reference
point connector is not in use.
3-9. Supplied ferrite core
To prevent malfunctions caused by noise from other equipment,
attach the supplied ferrite core to the head cable.
Firmly secure the ferrite core to the position nearest to the
interpolator.
When using an extension cable, be sure to attach the ferrite core to
the extension cable end nearer the interpolator.
ALM
LEVEL
SPEED
M
J70
0
OF
F
OFF
ON
OF
F
OFF
ON
ON
ON
ABS
1
1
2
3
4
5
6
7
8
9
10
2
3
4
5
6
7
8
9
10
OF
F
ON
MODE
Head cable
Ferrite core
Input/output cable
Summary of Contents for MJ100
