10
(E)
SQ57-Z Series, CH22 Series
6. Apply a thread-locking agent to the threaded areas, and install the sensor head.
Note
Take care that the reading part of the sensor head does not interfere with the scale.
At this point it is recommended to insert a 0.185 mm clearance gauge, loosely turn the mounting
screws, and check the clearance between the scale and the reading part of the sensor head.
M6 × 25
(9 N
t
m)
M6 × 25
(9 N
t
m)
M6 × 25
(9 N
t
m)
M6 × 25
(9 N
t
m)
Sensor head
Sensor head
Thread-locking
agent
Thread-locking
agent
<When using the stop surfaces>
<When using parallel pins>
Unit: mm
Fig. 3-8
7. Use the supplied clearance gauge and check that the clearance between the scale and the reading part
of the sensor head is 0.185
+ 0.065
–
0.085
mm.
* Three types of clearance gauges (0.1 mm, 0.185 mm, and 0.25 mm) are supplied. After adjusting the clearance with the
0.185 mm gauge, make sure that the 0.1 mm gauge can be inserted and the 0.25 mm cannot.
0.185
Clearance gauge
Clearance gauge
+ 0.065
– 0.085
<When using the stop surfaces>
<When using parallel pins>
Unit: mm
Fig. 3-9
Summary of Contents for SmartSCALE SQ57
