12
(E)
SQ57-Z Series, CH22 Series
Example 2: Installation when a stop surface of the scale and the sensor head is not made with
the bracket.
1. Adjust the parallelism of the scale bracket and sensor head bracket with respect to the machine guide,
and then secure in place.
Adjust the height and parallelism of the sensor head bracket with respect to the scale bracket, and then
secure in place.
0.05
MG
77
±0.5
0.05 or less
Sensor head bracket
Sensor head
bracket
Scale bracket
Unit: mm
Fig. 3-11
2. Check the label attached to the scale to make sure that the serial No. matches that of the sensor head.
(See Fig. 3-6.)
3. Remove the label. (See Fig. 3-7.)
4. Adjust the parallelism with respect to the machine guide while measuring surface A with a dial gauge,
and tighten the set screws.
<Measurement method>
Measure near the positions at both ends of the eff ective length on surface A.
0.2
MG
A side (installation guide)
Unit: mm
Fig. 3-12
Summary of Contents for SmartSCALE SQ57
