DataLogger Series 4 Technical Manual
February 2021
Page 7 of 28
1. Overview
The DataLogger Series 4 (DLS4) is designed to
simplify troubleshooting by recording and
presenting detailed operational histories that are
necessary for cost-saving preventive
maintenance.
The DataLogger Series 4 is a logging device
that allows the operator to easily access Run,
Alarm, and Fault histories for the IMPULSE
®
•G+
Mini, IMPULSE
®
•G+/VG+ Series 3, and
IMPULSE
®
•G+/VG+ Series 4 drives. It is also
the standard keypad included on the
OmniPulse
®
DDC Series 2 and MagnePulse
®
DMC Series 2 drives. The DLS4 can store 11
parameter sets. It is designed to be a fit-and-
form replacement to the
IMPULSE•G+/VG+
Series 4 keypad. The supplied RJ45 cable is
required to connect the DataLogger Series 4 to
an IMPULSE
•G+ Mini or IMPULSE•G+/VG+
Series 3 drive. The DLS4 stores trending data
which can be used by IMPULSE
®
•Link 5 to
generate charts of various monitors.
The DataLogger Series 4 kit consists of:
▪
DataLogger Series 4 unit
▪
Quick-Start Guide
▪
RJ45 cable for drive connection
▪
USB cable for PC communication
▪
USB flash d
rive including the IMPULSE•Link 5 Viewer software installer
The DataLogger Series 4 can log:
▪
5000 Run Events
▪
400 Alarm Events
▪
400 Fault Events
▪
Over 900MB (approx. 300 hours) of monitor data (U01-01~U01-12, plus 10 selectable monitors)
▪
11 parameter sets
All data acquisition is automatic. Data viewing and analysis is available via the LCD display or by
connecting to your PC, via USB, and viewing the data in
the IMPULSE•Link 5 software. The DLS4
receives power from either the drive or by USB when connected to the PC. The internal clock is powered
by a battery.
NOTE: Cables for remote mounting must be less than 50 feet in length.
