Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
16
of
34
4.5:
Anchor Hanger (FS-AH)
4.5.(a):
Slide anchor hanger assembly over the end of the line element near the mounting bracket.
NOTE: Slide the anchor hangers on the line element, with the clamping nut of the hanger facing the outside
of the system, for ease of installation.
4.5.(b):
Remove nut, lock washer and flat washer from anchor hanger mounting bolt.
4.5.(c):
Snap the line elements into the snap-in hangers located next to the anchor hanger location.
4.5.(d):
Insert anchor hanger mounting bolt through the mounting bracket.
4.5.(e):
Assemble washer, lock washer and bolt to hanger base bolt and hand tighten.
4.5.(f):
Tighten anchor hanger clamping nuts 8 ft-lb. (48 in-lb.) Do not over-tighten.
4.5.(g):
Verify alignment and tighten nut of mounting bolts 15 ft-lb. (180 in-lb.)
NOTE: Tools Required: ½” Wrench or Socket and 7/16” Wrench
