Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
19
of
34
5.3.(c):
Push end cap hardware until it comes in contact with the conductor bar cover, and
tighten the nut 55 in-lb. Trim the bolt to be flush with the nut.
5.3.(d):
Push the end cover boot over the end of the bar and end cap hardware. Manipulate end
cover boot until the nut relief in the boot is directly over the end cap hardware.
The boot may become less pliable in low ambient temperature installation. Keeping the boot in a
warm location (+65°F) until needed is recommended.
NOTE: Tools Required: 3/8” Wrench or Socket
Ensure trimmed
fastener
