Electrification FS Conductor Bar System Instruction Manual
October 2019
Page
28
of
34
8.4:
In-Line Power Feed Assembly For Use As End-Line Power Feed Assembly
8.4.(a):
Slide cover of the line element back approximately 12 inches.
8.4.(b):
Cut and remove 10” of the cover protruding from the end of the line element. Slide the
remaining cover back into place on the line element.
8.4.(c):
Using the 10” section of cut cover, remove another 2” of cover to produce (1) 2” section
and (1) 8” section. Discard the 2” section.
8.4.(d):
Slide the joint assembly, from the In-Line Power Feed Kit, onto the end of the bar where
the cover has been removed.
8.4.(e):
Slide the 8” section of the cover onto the line element to meet the Joint Assembly. The
line element should now look like a standard piece with a Joint Assembly 10” from the end of the
line element.
8.4.(f):
Continue the In-Line Power feed Assembly according to the instructions on page 24 for
90/110/125 Amp systems, or page 26 for 250/400 Amp systems.
