Enrange MLTX2 Intrinsically Safe
Transmitter Instruction Manual
April 2019
Page 28 of 44
WARNING
DO NOT ASSUME THE POWER IS OFF IN THE RECEIVER BECAUSE THE TRANSMITTER IS TURNED OFF.
FAILURE TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO
EQUIPMENT.
4.2.2.5 Backlight Timeout
The Backlight timeout setting controls the amount of time that the backlight will stay on after a command
is pressed before it automatically shuts off.
Backlight Timeout can be set from 1 to 30 seconds.
Setting Timeout to disable will disable the backlight.
Setting Timeout to “always on” sets the backlight to be on continuously while the transmitter is on and
active.
NOTE: Leaving the backlight on longer will decrease the battery run time and will require more frequent
battery replacement.
4.2.2.6 Password Enable
This setting enables or disables the requirement of entering a password into the transmitter to enter setup
mode.
When the disabled setting is selected the user will go directly into setup mode without being prompted to
enter a password.
Magnetek strongly recommends enabling the setup mode password setting to prevent unauthorized or
accidental changes to parameters.
NOTE: The unit is shipped with the password requirement enabled and utilizing the factory default
password.
4.2.2.7 Change Password
This allows the user to change the password needed to enter the setup mode.
The password must consist of 4 digits.
4.2.2.8 IR Configuration Receiver
IR Cfg Recv function in the setup allows the transmitter to link to a compatible receiver by using IR
(contact the factory to determine if your receiver is compatible) and automatically set up the channel and
access code to match the linked compatible receiver.
After selecting this option, point the IR window of the transmitter at the desired receiver to control and
momentarily press the OFF-ON-START toggle to the Start position and release. The graphic user
interface will display “Attempting” while scanning for the receiver’s IR signal. If the receiver is in range
an
d IR link is made, the message will change to “Success”.
