Enrange MLTX2 Intrinsically Safe
Transmitter Instruction Manual
April 2019
Page 29 of 44
NOTE: The changes to the transmitter’s channel configuration and access code will not be saved until the
operator selects the Exit with Save option to exit the Setup Mode.
If the receiver is not in
range, the scan will time out and the graphic user interface will display “Failed”.
The operator can reposition the transmitter and reattempt to establish the IR link with the receiver by
toggling the OFF-ON-START toggle to the Start positionmultiple times.
NOTE: The access code and channel will not be updated to match the desired receiver until “Success” is
displayed. Once “Success” is displayed, subsequent “Failed” messages will not overwrite the access code
and channel obtained in the successful IR link until a new successful IR link is made.
The IR configuration function will only update channel and access code information if the receiver and
transmitter are programed at the factory with the same project identification number. If the
receiver/transmitter pairing is not programmed with the same project identification number, the graphic
user interface will display “Err Project ID” when an IR link is attempted. The IR link will not be successful
and the access code and channel information in the transmitter will not be changed.
If the receiver and transmitter IR pair is not operating in the same frequency band when an IR link is
attempted, the graphic user interface will display “Err RF Freq”. The IR link will not be successful and the
access code and channel information in the transmitter will not be changed.
4.2.2.9 RCP IR Configuration
The RCP IR Configuration feature (supported in common code version 6.2 and greater) allows the
transmitter configuration to be read and written through the IR Adapter port. Contact customer service to
determine if your transmitter is compatible. You will also need to have an IR Adapter available to
configure the device.
Figure 9: MLTX2 IR Window and LEDs
After selecting this option through, point the IR Adapter at the IR window located on the bottom of the
transmitter (as seen in Figure 9.)
The transmitter’s display will show:
> RCP IR Cfg
Ready...
Press start to exit
At this point, the transmitter is ready to send and receive commands from RCP. When finished press the
OFF-ON START toggle to exit back to the menu.
NOTE:
See RCP User’s Guide for detailed instruction on reading and writing the configuration.
