Pedestrian Barrier High Door MPH 112
Assemble end housing
58
5817,5005EN / Version 01
8.6
Post-installation check
The following points have to be checked after the electrical
installation of the pedestrian barrier:
Does the supply voltage match the specification on the type
plate?
Are the pedestrian barriers connected according to wiring
diagram?
Are all screws firmly fixed?
Have all covers been properly assembled?
9 Assemble
end
housing
9.1
Assemble end housing
Assemble end housing
Assemble end housing in reverse order as at dismantling. Refer
also to Page 35, Fig. 11.
1. Assemble end housing. Pay attention that no cable or plug is
pinched.
2. Tighten lower central screw.
3. Tighten connecting screws "end housing
central housing" in
both upper corners.
4. Insert plug for the Barrier End Display.
5. Insert plug for the light barriers.
6. Close top cover.
9.2
Post-installation check
The following points must be checked after assembly and
installation of the pedestrian barrier:
Are all express anchors firmly fixed?
Are all screws firmly fixed?
Have all covers been properly assembled?
