Pedestrian Barrier High Door MPH 112
Assembly and installation
5817,5005EN / Version 01
45
2. Tighten highest and lowest clamping screw, so that the glass
wing is fixed but can be positioned.
3. Position the glass wing. Set the following measures between
housing and glass wing:
MPH Standard: 150 mm
MPH Wide: 190 mm
Due to manufacturer tolerances, there may be differences.
4. Take the drive unit off its block. Loosen fixing screw. Refer to
Page 42, Fig. 14. Make sure that the counter nut is tightened
again to prevent unintended turning of the fixing screw.
5. Position drive unit at "glass wing open" and check if the glass
wing squares up with the housing to the passage side.
6. Should the glass wing not square up with the housing repeat
steps 2 to 5 to correct the appropriate difference.
7. Tighten the clamping screws progressively and alternately to a
torque of approx. 15 Nm. Refer to Page 44, Fig. 16.
7.8
Assemble the cover strip
1. Hinge cover strip to the carrier pin.
1
2
3
4
Mag00023
5
Fig. 17: Changing the cover strip
1 Carrier
pin
2 Carrier
3 Cover
strip
4 L-lever
