Pedestrian Barrier High Door MPH 112
Configuration of pedestrian barrier
5817,5005EN / Version 01
63
10.2.2 DIP switch block S2
DIP S2.x
Function
Description
The program mode determines which control program is used
when power to the barrier is switched on.
Options
DIP S2.1
DIP S2.2
Program mode
OFF
OFF
1 = not valid
ON OFF
2 = MPH
OFF
ON
3 = KPH
1 and 2
Program mode
ON
ON
4 = not valid
Using DIP switches S2.3 and S2.4, you can determine in
which direction the pedestrian barrier may be used.
These two DIP switches are used together with digital inputs
IN1 to IN3 of the MBC-110 to select the operating mode of
the pedestrian barrier
Options
DIP S2.3
DIP S2.4
Permitted
direction of
passage
OFF OFF Passage is not
possible in either
direction
ON OFF Passage only
permitted in the
entry direction
OFF ON Passage only
permitted in the
exit direction
3 and 4
Permitted direction of
passage
ON ON Passage permitted
in both directions
5 Reserved Not
reserved
6 Reserved Not
reserved
7 Reserved Not
reserved
8
Behaviour when
obstruction detected
This DIP switch determines the behaviour of the barrier after
a glass wing has contacted a person or a piece of luggage.
Options
OFF: Glass wings continue to press
ON: Glass wings open immediately and close again at
reduced speed depending on the status of the light
barriers
Table 11: DIP switch Block S2
