Full Height Turnstile MPT-152
Assembly and installation
29
NOTE!
Mount the support beam so that the cover is ac-
cessible from inside, from the secured area. See
Fig. 5.
5.4.1
Mounting the cage halves and guide combs on the foundation
NOTE!
The foundation must have hardened off.
Foundation and empty conduits must be tested pri-
or to commencing assembly.
The turnstile is mounted to the foundation by
12 composite anchors. The mounting material is
included in delivery.
1. Make the bore holes as per the drilling plan (see page 25,
Fig. 2). Use the drilling jig supplied.
2. Carefully remove any sand and swarf from the bore holes and
their immediate vicinity.
3. Set the anchor bolts supplied as shown on the enclosed de-
scription and allow hardening.
Fig. 6: Power and control cables
4. Pull the power cable and any control cables completely
through the tube of the guide comb (Fig. 5, Pos. 1) and/or the
cage halves half (Pos. 2).
