Full Height Turnstile MPT-152
Maintenance
54
Personal protective equipment
The following must be worn during maintenance work:
Work clothes
Protective gloves
Safety shoes.
9.2 Cleaning
Aggressive cleaning aids and
substances
NOTICE
Unit damage possible!
Aggressive cleaning agents and substances can
damage or destroy electrical cables and compo-
nents.
– Do not use cleaning agents with aggressive in-
gredients.
Carrying out cleaning work:
1. Isolate the power supply and secure to prevent restart.
2. Remove dirt as required.
Clean stainless steel surfaces and power-coated parts reg-
ularly with a damp cloth and then dry off carefully.
Clean stainless steel surfaces with an appropriate cleaning
aid. We recommend the stainless steel polish from 3M. Ap-
ply a thin even layer of stainless steel cleaning agent and
rub dry using a clean and dry disposable cloth.
Never use wet cloth.
Wash off zinc surfaces using water and a soft cloth. Re-
move stubborn marks as soon as possible using a standard
commercial cleaning agent for zinc (e.g. ROTOL New For-
mula A2).
3. Remove oil deposits using an absorbent material.
4. Vacuum away dust from inside the support beam.
5. After cleaning, check that all previously opened covers have
been properly closed and that the functions of any safety
equipment fitted have been restored.
