Full Height Turnstile MPT-152
Troubleshooting
57
10.1.1 Display of the error codes at the MBC-110
When the DIP switch S1.8 is set to OFF (factory setting), the dis-
play indicates a code if an error occurs. See also page 49, Table 7.
During normal operation mode the point continuously flashes at
0.5 Hz.
The error codes are shown on the single-character display of the
MBC-110. The numerals and letters in the error code are displayed
successively for 2 seconds at a time.
Example
The error code E05 is displayed as follows:
1. E
(Error)
2. Pause
3. 0
4. Pause
5. 5
6. Pause
7. Steps 1 to 6 are repeated.
10.1.2 Display of the software version of the MBC-110
If the DIP switch S1.7 is ON the display shows the current soft-
ware. See also page 49, Table 7.
The numerals and letters in the software version are displayed
successively for 2 seconds at a time.
Example
The software version 1.4 is displayed as follows:
1. u
2. 1. (1st numeral with stop)
3. 4 (2nd numeral without stop)
4. Pause
5. Steps 1 to 4 are repeated.
