21
MGC control unit
Parameterising control unit
3.5.2
Further symbols
Clamp
Description
Wrong password entered. Access denied.
Reset values to factory settings. To do this, you must enter the
password "0000".
The next validation is blocked by the random function.
There is information. Check the "Information" menu. To do this,
press the left operating button.
There is a warning. Check the "Information" menu. To do this, press
the left operating button.
There is an error. Check the "Information" menu. To do this, press
the left operating button.
The passage in zone controlled direction cleared is cleared.
The passage in zone not controlled direction cleared is cleared.
The passage is enabled in both directions.
Table 9:
Further symbols
