60
Control unit MGC mTripod
Description of menus and parameters
6.10
"Factory settings" menu
IMPORTANT!
The parameters of the control unit are stored in the three
memory areas "Default settings", "Factory settings" and "User
settings".
The default settings are identical to the factory settings in these
operating instructions. The default settings are firmly store din
the firmware and cannot be changed.
The factory settings can be assigned factory- or product-specific
settings.
The user settings are the operating parameters.
Options in the "Factory settings" menu
The menu "Factory setting" offers the following options:
›
Restore factory settings: The stored parameters in the memory area
"Factory settings" are accepted as operating settings.
›
User settings as factory settings: The current parameter settings are stored
as factory settings. These factory settings can be used to receive project-
specific settings.
›
Default settings as factory settings: The factory settings are overwritten by
the default settings.
If you would like to accepted the default settings as operating settings and the
factory settings were overwritten first, you need to use the option "Default
settings as factory setting" and then the option "Restore factory setting".
"Restore factory setting" option
The operational view is displayed.
1. Press the right button « ».
√
The "Main Menu" menu is displayed.
2. Select the menu "Factory setting" with the two middle buttons « », «
».
3. Confirm selection with the right control button « ».
4. Enter password "0 0 0 0".
5. Confirm password with the right control button « ».
√
The message "Restore to factory settings" appears.
6. Press the right button « ».
√
The safety prompt "Save changes?" appears.
Summary of Contents for mTripod
Page 86: ...86 Control unit MGC mTripod...
Page 90: ...90 Control unit MGC mTripod...
Page 91: ...91 Control unit MGC mTripod...
