36
Control unit MGC mTripod
Parameterisation directly at the control unit MGC
5.2
Entering password
You need to enter a password in the following cases:
›
You would like to change parameters in the control unit and the password
protection was activated.
›
You would like to restore the parameters to factory settings.
If a password is required, the following view is displayed:
Mag00
81
8
– – –
0
Password
Fig. 21: "Password" view
1. Use the two middle buttons « », « » to enter the first digit of the
password.
2. Use the right button « » to select the second digit of the password. The
following view is displayed:
Mag008
28
– –
*
0
Password
Fig. 22: "Enter second digit of the password" view
3. Use the two middle buttons « », « » to enter the second digit of the
password.
4. Use the right button « » to select the third digit of the password.
5. Use the two middle buttons « », « » to enter the third digit of the
password.
Summary of Contents for mTripod
Page 86: ...86 Control unit MGC mTripod...
Page 90: ...90 Control unit MGC mTripod...
Page 91: ...91 Control unit MGC mTripod...
