OPERATOR’S MANUAL
with Maintenance Information
Maintenance
75
6 Bring the machine to top drive speed
before reaching the test line. Release the
function enable switch or the joystick when
your reference point on the machine
crosses the test line.
7 Measure the distance between the test line
and your machine reference point.
⊙
Result: The machine stops within the
specified braking distance. No action
required.
¤
Result: The machine does not stop within
the specified braking distance.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.
8 Replace
the
brakes and repeat this
procedure beginning with step 1.
Braking distance, maximum
High range on paved surface 61cm
±
30cm
B-8
Test the Drive Speed - Stowed
Position
DINGLI requires that this procedure be
performed every 250 hours or quarterly,
whichever comes first.
Proper drive functions are essential to safe
machine operation. The drive function should
respond quickly and smoothly to operator
control. Drive performance should also be free
of hesitation, jerking and unusual noise over
the entire proportionally controlled speed
range.
Perform this procedure with the machine on a
firm, level surface that is free of obstructions.
1 Create start and finish lines by marking
two lines on the ground 12.2 m apart.
2 Turn the key switch to platform control. Pull
out the platform and ground red
Emergency Stop button to the on position.
3 Lower the platform to the stowed position.
4 Press the drive function select button.
a
a drive function select button
5 Choose a point on the machine; i.e.,
contact patch of a tire, as a visual
reference for use when crossing the start
and finish lines.
