MAINTENANCE
103
Replacement
Place a suitably sized container under the reduction
gear. Turn the reduction gear cap in position
1
.
Remove the cap and wait for the oil to drain out
completely.
Turn the reduction gear cap in position
2
. Fill oil
through the hole to the correct level.
Refit the cap. Repeat this operation for each wheel.
Steering elements
Lubrication
Lubricate the wheels rotation pins
1
by injecting
grease in the grease nipples provided for the purpose.
Remove the excess grease.
Lubricate the ball joint
2
injecting grease in the grease
nipples provided for the purpose. Remove the excess
grease.
Repeat the operations for each wheel.
Engine air filter
The efficiency and life of the engine depend greatly on
the quality of air taken in. A dirty or damaged air filter
can seriously affect the correct working of the engine
and increase the possibility of a fault.
Replace the air filters strictly according to the schedule
indicated in this Manual. Do not try to wash dirty
filters.
If the vehicle is expected to be used in environments
with a lot of dust or high concentrations of
contaminating or polluting agents in the air, halve the
time interval between one filter replacement and the
next.
Replacing the primary cartridge
Set the vehicle in the parking position. Rotate the
turret to the left through 45° to allow easier access to
the filter housing.
Lift the protective cover on the locking mechanism and
then use the key to open the trap-door and lift it to
access the filter compartment.
Unhook the four fastenings
1
and remove the filter
housing cover.
Grip the filter housing and remove it from its seat. Lift
the filter element out of the filter housing.
Wipe thoroughly inside the filter housing with a damp
cloth. Avoid the use of aggressive solvents or products
as these can damage the safety filter or the filter
housing.
Install a new filter element. Make sure the filter
element is inserted properly in its seat. If installation is
difficult, grease the rubber gasket
2
slightly with
silicone grease.
2
1
1
1
2
Summary of Contents for RTH 4.18
