OPERATION
51
The gear must be engaged (forwards or reverse) by
pressing the enable button on the joystick. Otherwise
the incorrect procedure will be displayed on the
touchscreen panel.
Apply reverse gear only with the vehicle stopped.
Otherwise the incorrect procedure will be displayed
on the touchscreen panel.
Lights/windscreen wiper selector for
RTH 4.18 models
The lever on the left of the steering wheel controls the
direction indicators, work lights switch and
windscreen wipers.
Direction indicators
To activate the direction indicators:
-
right: push the lever forwards,
-
left: pull the lever backwards.
The direction indicators are deactivated when the
lever is in the central position.
Lights switch
To activate the low beams:
-
move the lever down for continuous activation,
press slightly towards the handwheel to activate
flashing of the high beams. The lever will return
immediately to the neutral position when released.
Horn
To use the warning buzzer press the button in the
centre at the tip of the lever.
Do not use the warning buzzer in densely populated
spaces or where expressly banned by means of signs.
NOTE: the warning buzzer emits a short warning if
connected with a radio control (optional).
Windscreen wipers
The vehicle has three windscreen wipers. The wiper on
the rear window is activated separately, while those
on the upper window and windshield can only be
activated simultaneously.
Controls:
-
O
: all windscreen wipers deactivated;
-
I
: activates intermittent movement of the front and
upper windscreen wipers;
-
II
: activates continuous movement of the front and
upper windscreen wipers;
-
Ј
: activates the rear windscreen wiper.
To active dispensing of the window washer liquid press
the crown at the tip of the lever.
Parking brake
The switch for engaging/disengaging the parking brake
is under the steering wheel.
Press the switch to apply the parking brake. Check to
make sure the indicator light in the main page of the
multiple functions display lights up.
To deactivate it, sit properly in the seat, start up the
engine, check to make sure the reverse gear is in
“neutral” then press switch
(P)
to release the parking
brake.
Check to make sure the indicator light in the main page
of the multiple functions display switches off.
At a speed below 3 km/h, if the driver gets up from the
seat, the vehicle stops automatically, and the parking
brake is applied.
Summary of Contents for RTH 4.18
