25
Advert 1：
After setting up the EDID, for different computers and graphics card
outputs, it may be necessary to restart the computer or unplug the
signal cable. In the display settings menu of the computer, select the
corresponding resolution.
Advert 2：
To crop an image, first select input 1 to input 7, and then select the
signal to be crop in the corresponding area below.
Advert 3
：The image crop function is the function of selecting a portion of the
input signal and outputting it to the LED display screen according to
the layer size. Therefore, the size and position of image crop are
limited to the resolution of the input signal. The various setting
parameters in the above table are mutually restrictive.
configuration
DVI 1
Indicates the input sequence number and input signal
currently being configured for EDID
Horizontal
Resolution
Modify the horizontal resolution of EDID
Vertical
Resolution
Modify the vertical resolution of EDID
Reset
Reset all parameters of EDID
Application
Write EDID parameters to the computer graphics card
Advanced
Do not adjust or modify any parameters in the advanced
submenu without the support of our company's technical
personnel. If you accidentally modify the menu, you can
click the reset button.
H Blank
Modify the horizontal blank of EDID
V Blank
Modify the vertical blank of EDID
3D Setting
3D switch option, 3D synchronization mode divided into L&R_ Interlace
and Side By Side modes;
3D phase delay parameter range 0-1000
Summary of Contents for LED-F816-3D
