3
Set-Up (cont’d)
5. Next, connect the Monitor Power Cord
on the rear
panel of the camera. Note: the power supplied to the AC OUT jack
turns on & off with the camera power switch.
to the AC OUT jack
6. Finally, connect one end of the DVI signal cable to the Monitor Jack
and the Control Cable to the Control Jack on the rear panel of the
camera.
4. Connect the AC Power Cord to the AC IN jack on the rear panel of the
camera. Plug the other end of the AC Power Cord into wall outlet or
surge protected power strip (not included).
!
CAUTION: THE POWER SUPPLY CORD IS USED AS THE
MAIN DISCONNECT DEVICE. ENSURE THAT THE SOCKET-
OUTLET IS LOCATED NEAR THE EQUIPMENT AND IS
EASILY ACCESSIBLE
DVI Signal Cable
Control Cable
Power Cord (to Wall Outlet)
Monitor
Power Cord
