Page 2
©
2014 Magnum Energy, Inc
.
Installation
2.0 Installation
Review this section and the Important Product Safety Instructions on page ii before proceeding
with the installation of your remote.
WARNING:
Installations should be performed by quali
fi
ed personnel, such as a licensed
or certi
fi
ed electrician. The installer determines which safety codes apply and ensures
all applicable installation requirements are followed. Applicable installation codes vary
depending on the speci
fi
c location and application.
CAUTION:
When connecting battery power to the inverter, all battery negative
connections must be connected prior to the battery positive connections. When removing
battery power from the inverter, the battery positive should be removed before any
battery negative connections are disconnected. This prevents any communication chips/
lines from becoming the DC return path to the battery—causing permanent damage to
all connected accessories.
Summation:
Ensure all battery negative circuits are always connected before connecting
or disconnecting battery positive.
2.1 Pre-Installation
Before proceeding, read the entire Installation section to determine how best to install your ME-
ARC remote. The more thorough you plan in the beginning, the better your inverter needs will
be met.
2.1.1 Installation
Guidelines
• Before connecting any wires determine the remote’s cable route throughout the home or ve-
hicle/boat, both to and from the inverter.
• Always check for existing electrical, plumbing, or other areas of potential damage BEFORE
drilling or cutting into walls to mount the remote.
• Make sure all wires have a smooth bend radius and do not become kinked.
• If installing this remote in a boat, RV, or truck ensure the conductors passing through walls,
bulkheads, or other structural members are protected. This minimizes insulation damage
(such as cha
fi
ng) which can be caused by vibration or constant rubbing.
2.1.2
Unpacking and Inspection
Carefully remove the ME-ARC remote from its shipping container and inspect all contents. Verify
the following items are included:
• The ME-ARC remote display
• Bezel
• 50’ remote cable
• Eight #8 x 3/4 Phillips screws
• ME-ARC Owner’s Manual
If items appear to be missing or damaged, contact your authorized Magnum Energy dealer or
Magnum Energy.
IMPORTANT:
Save your proof-of-purchase as a record of your ownership; it is needed if the unit
should require in-warranty service.
2.1.3 Tools
Required
Installing the remote control is simple and requires the following tools:
• Phillips
screwdriver
• Level
• Drill
• Cut-out tool (knife/saw)
• Pencil
• Drill bit (7/64”)
