21
English
Connect the cables to the connector crimps
Tighten the connector by using the crimp
tool (Pic. 8).
Attention: In case of a single
connection cable (first connection), always
fold the cable double!
Always tighten on
both sides (on top and under) the wires
to the connector (Pic. 9). Cables must be
long enough and free to move and not be
subjected to mechanical loads.
To connect the crimp to the heating foil
Make sure that the crimp connection is
correctly set, max gap 1.3mm. Place the
crimp over the copper band on the heating
film. Tighten the crimp by hand (Pic.10).
Then tighten the crimp with the crimp tool
in a 45 degree angle from both sides (Pic. 11
and 12). Connect the heating foils in parallel
with the double insulated cable. (Page 10
and 11)
To insulate the crimp connection
Cut out 2 pieces of 50x50mm PVC tape.
Place it on both sides of the crimp
connection. The tape must end at least 5mm
from the edge of the crimp (Pic. 14).
10
11
12
13
ATTENTION!
Crimp from both sides in a 45 degree angle!
45o
ATTENTION!
Crimp from both sides in a 45 degree angle!
ATTENTION!
Tape all the copper end conductors with PVC tape
45o
