Feed Speed Control
Your machine is equipped with a spiral, serrated
infeed roller and a solid steel outfeed roller. When
the feed rollers are engaged, they turn to feed the
stock The Feed rollers slow automatically when the
machine is under heavy load for best planing under
all conditions. The feed rollers are driven by chains
(D) Fig. 33 and the sprockets (E), which takes
power directly from the cutterhead through the oil
bath gear box (F) Fig. 33
There are two feed speeds in the gear box by using
the shift lever (G) Fig. 33 to pull out or push in, and
the feed speed range as shown in Fig. 34.
FEED ROLL SPEED RATE
Speed rate of feed roll is transmitted by shaft gears
in gear box.
Shift gears handle, shown as Fig. 34 There are
three kinds of operations of gear box by using shaft
handle to pull or push. In the position A feed roll is
operating on rate 20 FPM. Shown as
Fig. 16 In the position 13 feed roll is operating on
rate 0.
In the position C feed roll is operating on rate 16
FPM.
Return Rollers
The two return rollers (A) Fig, 35 on the tsp.of the
machine serve as convenient stock rest. When
planed lumber is returned to the infeed side, it saves
time and motion, as shown in Fig. 35.
Accessory Dust Collector Hood
Dust collector hood is standard accessory.
Assembled to the rear of the planer using Hex. Hd.
Screws and washers. It provides an efficient means
of maintaining a clean and safe work area as shown
in Fig. 35 (B).
WARNING
IF, AFTER READING THIS MANUAL YOU ARE
STILL UNSURE ON HOW TO SAFELY OPERATE
THIS MACHINE DO NOT OPERATE UNTIL YOU
HAVE RECEIVED FURTHER INSTRUCTIONS
FROM A QUALITIED PERSON.
Fig. 33
Fig. 34
Fig. 35
D
H
E
G
F
A
RETURN
B
