ADDITIONAL SAFETY RULES FOR AUTO-FEED PRECISION PLANER
1.
If you are not thoroughly familiar with the operation of planers, obtain advice from your
supervisor, instructor or other qualified person.
2.
Keep cutterhead sharp and free of all rust and pitch.
3.
Check material for loose knots, nails and other defects.
4. Remove shavings only with the power off.
5.
Keep hands away from the top surface of the board near the teed rolls.
6.
Check that switch is in OFF position before plugging in power cord.
7.
Before moving table upward or downword, loosen locking knobs.
After choosing the proper position tighten locking knobs.
The locking knobs are on the right side of machine as shown in PG 6.
8.
Be sure the knives of cutterhead are correct and all hex screws are secured tightly before use.
9.
Keep hands away from the feed rolls and the cutterhead.
10.
Do not operate machine while the gear cover is open.
11.
Remove adjusting tools and loose articals from machine before operating.
UNPACKING AND CLEANUP
To ensure maximum performance from your planer, clean it properly; and install it accurately before
use. As soon as you receive the planer. we recommend you follow these Procedures:
1.
Inspect packing crate for damage in transit. Record damage and report it immediately to
shipper.
2.
Open crate and check that machine arrived in good condition. If not, let your industrial
distribution know immediately.
3.
Before lifting machine, remove all bolts locking it to its shipping base.
4.
Transport machine to location with a hand truck or dolly.
5.
Remove the protective coating from the table, bed rolls, feed rolls. cutterhead and loose items
packed with the machine, including lifting handles and motor pulley.
6.
This coating may be removed with a soft cloth moistened with Kerosene. NOTE: Do not use
acetone, gasolink'or lacquer thinner for this purpose.
7.
Do not use solvents on plastic parts; solvents dissolve on damage plastic. 8 Care must be
taken when cleaning the cutterhead as the knives are in the cutterhead and knives are very
sharp.
