Fig. 1
Fig. 2
Fig. 3
Lifting Handles
There are four lifting handles, furnished. All lifting
handles are of hidden type. Pull the handles out
for use, push in when not in use. Two of the lifting
handles (A) are as shown in Fig. 1
Lifting Planer
It any type of sting is used to lift machine. be
sure to attach to lifting handles only. Be sure that
machine is kept in level position while lifting, as
shown in Fig. 2
Stand Assembling
For best planing performance, locate planer on
solid, level foundation. With machine in position,
test table surface lengthwise and crosswise with
machinist level. Place metal shims under low
corners. Check that all four corners are supported,
then tighten lag screws, restest level of table
surface in both directions; and adjust if necessary.
A
