Assembling And Aligning Motor, Motor
Pulley And Belt:
1. Assemble the motor pulley to the motor shaft
with the key and tighten the screw in the
motor shaft, as shown in Fig. 9.
3. Using a straight edge, align the motor and
cutter-head pulleys as shown in Fig. 11,
the motor plate (B) Fig. 10 Can be moved
for alignment by loosening the set screws
(C) in the motor plate (B) as shown in Fig. 10
4. Assemble the belts to the two pulleys, as
shown in Fig. 11. And adjust for the proper
belt tension by raising or lowering the motor
plate, as shown in Fig. 12, then tighten the
nuts (A) Fig. 12. Correct tension is obtained
when there is approx. 114" deflection of the
center span of the pulleys by using light finger
pressure.
2. Assemble the motor to the motor mounting
plate, as shown in Fig. -10
NOTE: It is very important that the motor must
be mounted to motor plate by using the mounting
hardware (A) Fig. 10
Fig. 9
Fig. 10
Fig. 11
Fig. 12
J
H
A
A
C
B
B
A
