Shutdown and Cleaning
312082B
17
12. To preserve paint in hose:
a.
Point gun into paint pail.
b.
Unlock gun trigger lock.
c.
Pull and hold gun trigger.
d.
Turn AllControl to
PRIME/CLEAN GUN &
HOSE.
e.
Continue to hold gun trigger until you see paint
diluted with flushing fluid starting to come out of
gun.
13. While continuing to trigger
gun, quickly move gun to
redirect spray into waste
pail. Continue triggering
gun into waste pail until
flushing fluid dispensed
from gun is relatively clear.
14. Stop triggering gun. Engage trigger lock.
15. Turn AllControl to OFF.
16. Fill unit with Pump Armor
™
storage fluid. Read Long
Term Storage, page 21.
17. Clean gun fluid filter
(d) with water or
flushing solvent and
a brush every time
you flush the system.
Replace gun filter if
damaged.
18. Clean tip and guard
with water or flushing sol-
vent. A soft brush can be
used to loosen and remove
dried on material if needed.
19. Wipe paint off outside of gun using a soft cloth
moistened with water or flushing solvent.
Step 12 is for returning paint in hose back to paint
pail. One 50-ft hose holds approximately 1-quart
(1-liter) of paint.
ti8922a
ti9171a
ti9745a
ti8923a
d
ti9257a
ti9671a