CONTENTS
•
Causes of failure
•
The calibration jig, heating element, sensor, or wiring may be faulty.
•
Check that the Soldering iron and Hot air pencil are properly inserted in their jig’s
•
When the calibration is complete the
Complete
LED on the PCCU will light and the
Station will display
CAL
•
Disconnect the Station and jig’s from the PCCU.
•
Reset the 3005 Station for new values to take effect.
SPECIFICATIONS
Mains input voltage: 220V – 240V 50/60Hz
Power consumption: 0.6 Amps fuse 1A f/b
Output power: 24V 85W + 24V85W
Air flow: 1.5 to 6.5 litres/min
Temperature: Soldering iron 100° to 450° ± 4 °C
Hot air pencil 180° to 480° ±10 °C
Dimensions: L 250mm W 250mm H 105
Weight: 4 KGS (8.8LBS)
file:///C|/Documents%20and%20Settings/Lauren...her%20stuff/magnum/3005%20word%20booklet.htm (11 of 12) [03/03/2003 10:16:31 PM]
