CONTENTS
REMOVING PLCC using steel blade
Insert blade, which can be cut to any shape, into holder and fasten (fig 5)
Apply hot air continuously to both the blade and legs (fig 6)
While the solder melts insert the blade into the edge of the legs and move along. To
remove a glued component after desoldering blow hot air onto and under the component
then insert the blade under and remove
SOLDERING IRON model 1002/80w
•
The Soldering iron is supplied with a high energy 80w element to enable quick
thermal transfer to the soldering tip
•
A large selection of tips are available for fine pitch circuits
•
Always tin soldering tip before replacing in holder
•
Clean oxidation with damp sponge
SMD REMOVAL KIT
•
Air nozzle 3mm flat SM100402
•
Air nozzle 1.5mm round SM100401
•
Stainless Steel blade SM300406
•
Wire hook SM300409
•
Lifting fork SM300407
•
Solder braid SM300405
•
Stainless steel wire SM300205
•
Tweezers SM300402
•
Blade holder SM300403
file:///C|/Documents%20and%20Settings/Lauren/...ther%20stuff/magnum/3005%20word%20booklet.htm (6 of 12) [03/03/2003 10:16:31 PM]
