Magnum Innovations
5675 Hudson Industrial Pkwy, Suite 3 - Hudson, OH 44236 - phone 330.915.2382 - fax 330.529.5279 - www.magnum-innovations.com - info@magnum-innovations.com
Self-Powered Wireless Key Card Switch
Mx-EKCS
To Link or Unlink a Key Card Switch
1. Set the desired transceiver to the
desired link/unlink mode. (refer
to receiving device’s installation
guide).
2. Insert and remove a key card three
times quickly - there should be an
audible click each time.
-> The Key Card Switch is now linked.
Refer to the “Linking” section of the transceiver/controller installation
guides to verify the linking process.
Typical Interactions
The key card interaction depends on the type of transceiver it is linked
to, for example:
Linked to a Thermostat or HVAC Controller
•
Insert key card: normal mode is activated.
•
Remove key card: setback mode is activated.
Linked to a Load Controller
•
Insert key card: a wireless message is sent to close the circuits
and turn on all linked loads, according to user-defined program
settings.
•
Remove key card: a wireless message is sent to open the circuits
and turn off all linked loads.
NOTE: For multiple installations, e.g. front and back doors, all key
cards must be removed to send a message.
This device complies with part 15 of the FCC rules and Industry Canada ICES-003. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may
cause undesired operation.
IMPORTANT! Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio
exempts de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil
ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage
radioélec- trique subi, meme si le brouillage est susceptible d’en compromettre le fonctionne-
ment.
IMPORTANT! Tous les changements ou modifications pas expressément approuvés par la partie
responsable de la conformité ont pu vider l’autorité de l’utilisateur pour actioner cet équipment.
Contains:
FCC: SZV-PTM330U
IC: 5713A-PTM330U
Troubleshooting
Problem
Solution Checklist
The key card switch
does not generate a
message
•
Verify there is an audible click when
card is inserted or removed
•
Verify slot is clear of foreign material
or debris. Use forced air to clean.
The linked device
does not respond to
wireless messages
•
Check for environment or range
issues
•
Verify the device is linked
•
Check the transceiver connection
and the wiring for errors
•
Check if appropriate devices are
linked according to good system
planning