- 11 -
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
No sound, meter
lights are not on
•
Power cord
disconnected
•
Power off at source
•
Connect power cord
•
Check AC source
No sound, meter
lights are on
•
Interconnect not
properly installed
•
Preamp set to
incorrect source
•
Power amplifier is
off
•
Tube failure
•
Verify installation of interconnects
•
Turn preamp to input where tuner is
connected
•
On preamp defeat tape monitor
function
•
Turn amplifier on
•
Replace 6922 tube
Low signal
strength
•
Antenna not
connected properly
•
Incorrect antenna
Station too distant
•
Improper antenna
position/
placement
•
Check antenna connection
Check instruction manual for correct
antenna type
•
Change your antenna
•
Rotate your antenna or mount your
antenna higher or near a window if
indoors
Intermittent
sound
•
Mute switch is in
the “ON” position
•
Turn the mute switch to “OFF”
position
Tuner remote
does not work
•
Batteries dead
•
Buttons being held
too long
•
Improper sequence
•
Power switch should be in the off
position on standard tuners and the
remote must be activated with the
“Tuner Remote” power button on
the hand held.
•
All stations must be stored and
recalled with a two digit code from
01-20.
•
To store a preset press the “store”
button then the two digit preset.
Touch the buttons very quickly and
lightly.
•
To recall, touch “Preset” and then
the two numbers you want to recall
very quickly.
•
Make sure to turn the unit off with
the remote control “Tuner Remote”
after storing as this will save the
stations to the flash memory.
