General Description
Model TE100
Electronic Small Bagging Scale
1-4 Revision
001
1.6.1.2 Shut Off Gate
The shut off gate is used to stop product flow into the package, after target weight has been achieved.
1.6.1.3 Shut Off Gate Bearings
The shut off gate rides on a pair of sealed bearings. The use of bearings ensures that the shut off gate is
able to smoothly open and close.
1.6.1.4 Shut Off Gate Cylinder
The TE100 uses a pneumatic cylinder to open and close the shut off gate. The gate is mounted on the
left side of the scale cabinet.
1.6.1.5 Dribble Gate
The TE100 is equipped with a sliding steel gate that is used to control the flow of product from the
hopper. By using a dribble gate, the TE100 is capable of delivering product at two different feed rates.
The result is a more efficient fill cycle. When the dribble gate is all the way open, the TE100 is filling at
the bulk rate. When the dribble gate cylinder extends, it partially blocks the flow of product.
1.6.1.6 Dribble Gate Cylinder
The dribble gate is extended and retracted using a pneumatic cylinder that is mounted on the rear of the
TE100. The rod end of the dribble gate cylinder is bolted directly to the dribble gate, while the cylinder
end is bolted to the dribble gate cylinder mounting bracket.
1.6.1.7 Dribble Gate Mounting Rails
The TE100 is equipped with two aluminum rails on rear of the TE100. These rails provide the mounting
point for the dribble gate cylinder mounting bracket.
1.6.1.8 Load Cell
The load cell is used to sense the weight of the material in the package. As material is loaded into the
package, the load is applied to the load cell in a linear fashion. As the load increases, the voltage output
from the load cell increases.
CAUTION
A sudden jerk or shock, such as being struck by a tool or hitting the
spout, etc., can cause load cell damage. The load cell is NOT
covered by warranty.
Figure 1-3.
Load Cell
Summary of Contents for TE100
