Magnum TexFinish 246185, Repair Manual

Preparation

309797P

5

Preparation

Pressure Relief

To reduce risk of injury, follow this procedure 
whenever you see this symbol throughout this 
manual, Also, perform this procedure whenever 
you:

• stop 

spraying. 

• 

check or repair any part of this system.

• 

install or clean spray nozzle.

1.

Turn Power Switch OFF.

2.

Trigger gun into material 
hopper.

3.

Open gun air valve.

Grounding and Electrical Requirements

This sprayer must be grounded. Grounding reduces the 
risk of electrical shock by providing an escape wire for 
the electrical current. The sprayer cord includes a 
grounding wire with an appropriate grounding plug. The 
plug must be plugged into an outlet that is properly 
installed and grounded in accordance with all local 
codes and ordinances.

Check with a qualified electrician or serviceman if 
grounding instructions are not completely understood, 
or if in doubt as to whether the product is properly 
grounded. Do not modify plug provided; if it will not fit 
the outlet, have proper outlet installed by a qualified 
electrician.

120V AC Systems

• This 

equipment 

requires a 120V 
AC, 60 Hz, 15A 
circuit with a 
grounding 
receptacle. Do not 
use an adapter 
with this product.

Extension Cords 

• 

Use only an extension cord with an undamaged, 
3-prong plug.

• 

For 25 to 50 ft (7.6 to 15.2 m) cords, use 3-wire, 14 

AWG (1.5 mm

2

) minimum.

• 

For up to 100 ft. (30.48 m) cord, use 3-wire, 12 AWG 

(2.5 mm

2

) minimum.

Auxiliary Air Compressor

Do not use an auxiliary air compressor with this spray 
system.

Generator Requirements

3500 W (3.5 KW) minimum.

Hose Size and Length

The system comes with a hose set consisting of a 3/4 in. 
ID x 25 ft (25 mm x 7.6 m) material hose and a 3/8 in-ID 
air hose. 

Do not use more than 25 ft. (7.6 m) of material hose.

WARNING

page 2

TI2458a

ti3160a

ti2448a

WARNING

page 2

WARNING

page 2

grounding prong

grounded 
outlets