6
Installing Tip & Guard
2.
Make sure tip & guard parts are assembled in order shown below.
metal seat
black rubber gasket
(for water-base paint)
retaining nut
Put metal seat and
black rubber gasket on
pencil point, and insert
them into guard
together.
Tip & guard are pre-assembled with black gasket for water-base paint.
Use yellow gasket for non-water/solvent coatings.
guard
SAFETY ON
Ensuring Correct Tip Setup
tip
SAFETY ON
(XR7/XR9)
SAFETY ON
(XR5)
1.
Put trigger safety lever in SAFETY ON position.
Fluid Injection Hazard See WARNINGS sheet.
15
Shutdown and Cleaning
InstaClean filter prevents
particles from entering paint
hose. InstaClean filter is self
cleaning, but remove and
clean it after each use for
peak performance.
NEVER LEAVE WATER IN PUMP. Continue with Replacing
Water with Storage Fluid, the final shutdown and cleaning
procedure (page 16).
InstaClean filter
Then unscrew
outlet fitting
Install open end of InstaClean filter in outlet fitting,
then screw outlet fitting into sprayer outlet.
1.
Remove InstaClean filter from sprayer, and check it for debris.
If needed, clean InstaClean filter with water and a brush.
First unscrew
hose
outlet fitting
2.
Install InstaClean filter, and reconnect hose to sprayer.
Cleaning InstaClean Filter
3.
Install InstaClean filter, and reconnect
hose to sprayer.