Please note that this product is not a toy and not suitable for youngters under the age of 16. Technical details may
be subject to changes and modifications. All images and designs are property of MAGOM HRC. For any doubts or
questions, please contact us throught www.magomhrc.com.
SCHEMA
www.magomhrc.com
504099-303
1-WAY VALVE M3
– SPECIAL FOR CRANE‟S LEGS
SPECS
•
1-way hydraulic valve (to control ONE movement).
•
Pressure: Up to 30 bars.
•
Recommended working pressure is 5-18 bars.
REQUIRED:
•
1 x micro-servo. We recommend HXT 900 (
6003-001
).
•
Hydraulic oil. We recommend MAGOM HRC hydraulic oil (
5050-001
).
Connect 1A-1B to leg Nr 1.
Working angle is
about 60º, same as
servo angle.
MICRO SERVO ASSEMBLY
14 mm
Cut the servo horn as
shown in the picture.
STEP 1
Total length must be 14 mm.
STEP 3
1. Mount the horn to the servo without screw.
2. Attach the servo to the valve (If necessary, loosen the valve tabs
before screwing the servo to find the midpoint and then retighten the
valve screws).
3. Servo horn must not press the rotating valve.
At the neutral point, the valve is closed.
1. Connect the servo to the receiver.
2. With the station on and the receiver powered, move the servo to the
neutral position with SUBTRIM / TRIM to position 0.
3. Place the valve rotor in the NEUTRAL POINT (see diagram).
STEP 2
Connect 2A-2B to leg Nr 2.
INPUT
–
from pump
OUTPUT
–
to tank
1A
2A
1B
2B
