4 - Installation
DynaFlex II| Product Family | Installation and Operation Manual
Page 25 of 78 (D998200554-10)
path and card slot entry, such as bugs / skimmers / tapping mechanisms, and their wires or antennas. Be
sure to select an installation height and mounting angle that meet this requirement.
4.4.4
How to Mount the Charging Cradle
To mount the optional charging cradle to a countertop, follow these steps:
1)
Determine how many charging cradles you will be installing. Any number of charging cradles can be
mechanically attached to form a single unified charging bank, using the tongue-and-groove joining
features on their sides (see
2)
Make sure you have a cable and corresponding USB receptacle for each charging cradle you are
installing. For best results, use the cable that is included with the device; it includes shielding at both
ends to reduce interference.
3)
Determine where the charging cradle(s) should be placed.
a)
If you will use the charging cradle’s micro suction feet for mounting, make sure you are mounting
on a clean, smooth, flat surface. Avoid rough, dirty, or uneven surfaces.
b)
Factors to consider include cable length, cardholder and operator ergonomics, and access for
cleaning, maintenance, and repair.
c)
If the charging cradle will be used for charging in handheld operations, unobstructed removal is
also a consideration.
4)
Connect each charging cradle to a USB port or to a USB charger with a minimum of 1A current
capability. For best results, use the cable that is included with the device. It includes shielding at both
ends of the cable to reduce interference.
5)
Join the charging cradles together into a charging bank, if desired.
6)
Press the charging cradle’s micro suction feet onto the mounting surface.
7)
To uninstall, twist the cradle to disengage the mounting feet. To separate two cradles, hold one cradle
down and pull gently up on the other.
