4 - Installation
DynaFlex and DynaFlex Pro| Three-way Secure Card Reader Authenticators | Installation and Operation Manual
Page 21 of 56 (
D998200382-10
)
cable clip for strain relief, to help stabilize the mechanical connection when cardholders or operators
move the device or the cable.
4)
Route the cable in the desired direction (e.g., out the back, left, right, or down into the countertop).
5)
Connect the other end of the USB cable to the charger or to the host’s USB port.
6)
As soon as the device starts receiving power through USB, it automatically powers on.
7)
If the specific device serial number you are connecting has not been connected to the host before, the
device shows
Welcome
on the display, and the Windows system tray on the host reports it is
Setting up a device
. When installation is complete (approximately 30 seconds later depending on
the host), Windows reports
Device is ready
, and the device shows in Windows Device Manager
under
Human Interface Devices
as two devices:
HID-compliant vendor-defined device
with
VID
0801
and PID
2020
, and
USB Input Device
.
8)
After successfully connecting to the host operating system via USB, the device shows
Welcome
or a
customized graphic on the display.