4. Install Ink Cartridge(s)
•
Remove the outer cover by pressing the release buttons on each side and lifting the cover.
•
Remove the center cover by pressing the rear/front release buttons and lifting the cover.
•
Ensure the printer latch is down and locate the alignment pegs on the Printer/Cartridge and the guide holes in the Printer Base (Figure 4).
•
Slide the alignment pegs into the guide holes as indicated.
•
Raise the latch so that it touches the Printer/Cartridge.
•
Press the latch into the lock position, and move the Cartridge slightly to ensure it is locked.
•
If needed, perform steps 1-4 on the Front Printer/Cartridge located inside of the exit path.
Figure 4. Rear Print Cartridge Installation/Removal
MagTek®, MagnePrint®, and MagneSafe® are registered trademarks of MagTek, Inc.
MAGTEK: Registered to ISO 9001:2015 © Copyright 2021 MagTek, Inc. PN D99875344 rev 30 4/21
MagTek
®
Inc., 1710 Apollo Court, Seal Beach CA 90740 | p 562-546-6400 | support 651-415-6800 | f 562-546-6301 | www.magtek.com
Setup and Installation (Continued)
5. Run Excella STX Demo
•
Click on the Excella STX Demo icon to run the demo.
•
The Demo’s main screen will be displayed (Figure 5).
•
In the “Select Device” window, choose the device you want to connect
(USB or Ethernet).
•
Click on the “Connect” button.
•
Based on the document you want to read, click on one of these
buttons:
•
“Check”, to read and scan checks (the left LED is blinking)
•
“Card”, to read and scan ID cards (the right LED is blinking)
•
“Check/Card”, the unit will accept either a check or a card (both
LED’s blinking)
•
Feed the appropriate document.
•
The unit will remain in the Read/Scan mode until the “Stop” button is
clicked.
Figure 5. Excella STX Demo
