w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
10
If you are the proud owner of a MAGURA suspension fork with FIRM-tech equipment,
mounting the brakes is a breeze. Fit the fork and mount the brake lever to the handlebar
as described. Fit the slave cylinders of the brake as shown on page 18 of this manual.
1. Check out the double quick release comfort!
To
open
it push the quick
release in direction of the wheel; you can now move the brake cylinder to change your
wheel or the brake pads. Quick release tension is adjusted similar to standard version
(c.f. page 8)
2. Close the quick release
: Push the brake cylinder back towards the fork. Close
the quick release by doing the same. That’s all!
A booster is not necessary with FIRM-tech and not foreseen either. It is not
possible to mount one!
3.
Adjust the brake pads to the rim width with the 5mm allen screw which is integra-
ted in the brake cylinder. By turning the screw clockwise the pad approaches to the rim.
4.
With FIRM-tech you adjust the brake pad to the rim on both sides with the 5mm
allen screw.
Shorten the hose and pad wear adjustment as described in the respective
chapters!
8. Installation of FIRM-tech® models
