40
BA082901-en
Pos: 137 /Technis che Dok umentation/A lle G eräte/ Überschr iften/Üb erschriften 1.1/Ö/ Überschr ift 1.1: Öls tand prüfen @ 20\m od_1268827315211_ 75.d ocx @ 827233 @ 1 @ 1
6.5
Checking the Fluid Level
Pos: 138 /Technis che Dok umentation/Hebetechnik/- Archiv -/00 Hebetechnik - A lle/Inhalte/Inhalt: Öls tand prüfen HBZ ( Tex t)_ 12pt @ 26\mod_ 1325753708051_75.d ocx @ 1147041 @ @ 1
1 Lower lift and wheel-free jack into bottom position.
2 Check the fluid level (see label on power unit).
3 Open the filler neck and top up the reservoir. For specification and fluid quantity
see label on power unit.
4 Also perform a visual check of all hydraulic pipes and hoses.
Pos: 139 /Technis che Dok umentation/Hebetechnik/- Archiv -/00 Hebetechnik - A lle/Inhalte/Info!/Inhalt: I nfo - Tausch von Ö l und Druckschläuchen_ 12pt @ 26\m od_1325753763930_ 75.docx @ 1147073 @ @ 1
•
Replace the hydraulic fluid periodically, depending on aging, soiling and water
absorption.
•
When topping up, use fluid with the same specification only.
•
If the lift is operated permanently at an ambient temperature of < 15 °C (59 °F),
use hydraulic fluid with a lower viscosity.
•
The pressure hoses should be replaced as required, but after six years at the
latest.
Pos: 140 /Technis che Dok umentation/Hebetechnik/ DUO/082901 DUO CM/BA/Inhalt: 0829 Ö lstand prüfen ( Bilder) @ 43\m od_1447688675712_ 0.docx @ 2341904 @ @ 1
Pos: 141 /-----Format- ----/MANUE LLE R UMBRUCH Seitenumbruch @ 0\mod_ 1134403577687_0.docx @ 1277 @ @ 1
