BA081101-en
17
3.3.7 Hydraulic
Inclination
Optionally available for vehicles with lowered chassis.
Do not drive onto or off the runways before they are in fully inclined position.
Press and hold ENABLE RUNWAY INCLINATION button until the runways
are in fully inclined position.
Slowly center vehicle on runways.
Secure vehicle using parking brake and chocks.
Leave vehicle and stay clear of lift area.
Press and hold DISABLE RUNWAY INCLINATION button until the runways
are in horizontal position again.
For raising and lowering the lift see respective sections in this manual.
3.3.8
Setting the Runways on Locks for Wheel Alignment
Optionally available.
The green signal lamp lights up once the locking latches have fully engaged the serrations and
the system has been depressurized.
If the lift is equipped with double latches, check all four latches for proper engagement.
Press and hold SET ON LOCKS button until green signal lamp lights up.
If the green signal lamp does not light up, raise the lift briefly; then press and hold SET ON
LOCKS button again.
If the error persists, activate the automatic runway synchronization as follows:
Press and hold LOWER button until lift is in bottom position and green signal lamp lights up.
Then raise lift to desired height. Press and hold SET ON LOCKS button again.
Summary of Contents for DUO GN Series
