8-20
© Copyright Mahindra & Mahindra Ltd.012016
8.28.5 Low Speed Wiping
Push the wipe control stalk up to the position D to operate the
wiper at a fixed low speed.
8.28.6 High Speed Wiping
Push the wiper control stalk up to position E to operate the wiper at
a fixed high speed.
8.28.7 Auto Wipe (if equipped)
F
ATC
W12H91
Auto wipe senses water on the front windshield and activates the
wiper as necessary. The auto wipe button is located in the switch
bank under the HVAC controls. Press the button to enable the auto
wipe;
•
Front wiper will wipe once to indicate the entry into automatic
mode
•
Front wiper will wipe according to the rain intensity
•
Upon water splash (water pool on road side), auto wipe may
not work.
•
It might be possible that even when there is no water on
windshield, the wipers are activated. This is because of the
mist which may be present on the windshield and is normal
•
The RLS sensor cannot detect difference between water,
ice, snow, oil, etc. Under these conditions, the sensor may
behave improperly. If required, turn off the "AUTO WIPE"
mode manually.
Keeping the wiper in low/high speed will deactivate the auto mode.
8.28.8 Rear Wiper (if equipped)
Rotate the outer rotary switch (F) on the wiper control stalk to align
the ‘arrow’ on the switch to rear wiper symbol on the wiper stalk to
operate the rear wiper.
FEATURES AND CONTROL
