10
ADJUSTMENTS
Blade Reversing:
NOTE:
Rotate blade 180 degrees before using it in reverse
direction. Blade must be hooked to a tractor and
parking stand up to reverse blade.
Holes are provided for angling the blade in reverse
position to each side of center in 15° increments up to
45°.
Pull pin (item 1) and rotate blade (item 2) around
180°.
When blade is at desired angle, reinsert pin.
Blade Tilt
The blade may be tilted for ditching so one end is
lower than the other by adjusting the tractor’s lower
link leveling crank.
Blade Pitch
Blade pitch can be adjusted by lengthening or
shortening the tractor’s top center 3
-
point link.
Increasing blade pitch will increase blade’s ability to
dig.
Lengthen center 3
-
point link to increase blade pitch
when grading while traveling forward. Shorten center
3
-
point link to decrease blade pitch.
The opposite is true if backfilling. Shorten center 3
-
point link to increase blade pitch and lengthen center
3
-
point link to decrease blade pitch.
To help protect the Rear Blade from becoming
damaged while backfilling, lengthen tractor’s center 3
-
point link until the blade moves across the top of the
ground without forcing itself into the soil.
WARNING
TO PREVENT INJURIES:
Do not alter the rear blade. Altering the blade can affect
its performance and reliability causing damage to the
blade, tractor and/or injury. Always replace damaged
parts with original manufacturer parts.
Summary of Contents for BBLST5
